Twenty gallons of fresh water, molded to a footprint the rest of the Ronco line does not repeat - that is the Ronco Plastics B152's whole job. Boat compartments are leftovers, shaped by hull curvature and bulkheads rather than by tank catalogs, and Ronco's answer since 1974 has been to keep cutting new tools in Tustin, California until most of those leftovers have a tank that fits. The drawing below tells you in a minute whether this is yours.
If it is, the ordering step does the rest. The B152 ships with fittings installed per order: spin-welded or threaded, sized and positioned to your marks. Print the drawing, place your fill, vent, and pickup where the boat's plumbing wants them, and record the layout in the fitting planner on this page. The tank that arrives is specific to your installation, not generic to the model.
The molding ships at 93 lb, and a full load of water adds about 167 lb - 8.34 lb per gallon, every gallon. In potable service the polyethylene is FDA compliant and will not flavor the water or feed corrosion. Survey other capacities at boat tanks, the complete range at the Ronco Plastics hub, and shipping to your ZIP at the freight estimator. OneSource Plastics is an authorized Ronco Plastics dealer.
Technical drawing: download the Ronco Plastics B152 dimensional drawing - print it to plan your install and mark exactly where you want fittings located; Ronco installs spin-weld or threaded fittings to your marked spec.
