Parking & Traffic Aids

This high-visibility Lime rebar cap is a compact impalement-protection cover for exposed reinforcing steel and pipe. Sized 2.25" wide by 2.5" high (model A-5), it seats over protruding rebar ends to shield workers from the puncture and impalement hazard...

The A-10 Rebar Cap in high-visibility Lime is impalement-protection hardware for job sites with exposed reinforcing bar. Bar sticking up out of footings, foundations, and formwork is a serious hazard, and these caps fit over the ends to cover the point...

The Rebar Cap (item A-20, SKU 97-1813) is an impalement-protection cap that slips over exposed reinforcing steel on active job sites and work zones. Molded in high-visibility lime, it covers sharp vertical bar ends so crews, inspectors, and site visitors...

The 97-1814 Rebar Cap is a white impalement-protection cap sized to top exposed rebar and pipe ends. Molded to the A-20 profile at 2.75"W x 3.5"H, it fits rebar from 1" to 2-1/4" in diameter and also seats inside 1-3/4" ID pipe, giving crews one part...

The 97-1810 Rebar Cap is impalement-protection equipment sized to fit exposed vertical rebar on your jobsite. Finished in high-visibility orange with a 3.5"W x 3.5"H top face, this single unit slips over rebar sizes #3 through #8 (3/8" to 7/8" diameter)...

The OneSource Plastics 2053S Parking Aid Spike is a 14-inch galvanized spike used to anchor parking curbs, speed bumps, and wheel stops. At a half-inch diameter and just 2 pounds, it drops through the pre-formed holes in parking curbs to help hold them...

The Triangles-Fusee Kit (Single Triangle configuration) equips motorists and emergency responders with a compact, deployable warning device for the roadside when a vehicle is stopped or disabled. Part of the Triangles-Fusee warning-kit line, this...

The Cable Guard Adapter is a two-piece connector kit that links Cable Guard sections into one continuous run. It is engineered specifically for the 2070-5 Cable Guard and no other model, so confirm that unit before ordering. What it does Cable Guards...

The 2055CAP End Cap is a replacement component for OneSource Plastics' recycled-rubber parking speed bumps, engineered to finish off the 2056SB, 2054SB, and 2055SB systems. It squares off the open end of an installed bump, protecting the terminating edge...

The 2048C is a 12-foot length of 10# jack chain, sold on its own as a replacement or extension component for OneSource Plastics Parking Aids. Weighing about 6 pounds, this chain is the flexible link used to connect parking curbs, wheel stops, and rubber...

The 2048WC Heavy-Duty Wheel Chock keeps parked vehicles and trailers from rolling on grades and at loading docks. Molded from recycled rubber with a built-in eye-bolt for easy placement and retrieval, it holds up to constant use in fleet yards,...

This Fusees Holder Case is the storage core of the Triangles-Fusee warning-kit system, built to organize and protect emergency flares carried in trucks, fleet vehicles, and roadside response rigs. The blow-molded case holds twelve 20-minute fusees,...