Fourteen gallons is a deliberate choice, not a compromise: day sailors, small cuddy boats, and camp trailers that need a real pressurized water supply without surrendering a locker to it. The Ronco Plastics B160 serves exactly that brief - a marine fresh water molding in FDA-compliant polyethylene from Ronco's Tustin, California plant, where the line has been in continuous production since 1974.
Small tank, same treatment: the B160 ships with fittings installed per order, spin-welded or threaded to your marked sizes and locations. That is rare at this capacity - most small tanks come pre-drilled wherever the factory found convenient - and it means your fill, vent, and pickup land where your boat's plumbing runs. Print the drawing below, mark it, and set the layout with the fitting planner on this page.
The tank ships at 32 lb and holds about 117 lb of water full, so even here the mounting deserves a flat base and a strap. Once installed, the seamless polyethylene asks for nothing - no coatings, no anodes, no taste. If the size is close but not right, step through the boat tanks range or the full Ronco Plastics line; shipping to your ZIP is at the freight estimator. OneSource Plastics is an authorized Ronco Plastics dealer.
Technical drawing: download the Ronco Plastics B160 dimensional drawing - print it to plan your install and mark exactly where you want fittings located; Ronco installs spin-weld or threaded fittings to your marked spec.
