Sixty-five gallons of fresh water turns a weekender into a passagemaker, and the Ronco Plastics B292 is one of the workhorse moldings Ronco builds for exactly that upgrade. This is a substantial marine tank - 103 lb empty, about 542 lb full - shaped to run long and low against the hull where big water loads belong. Water rationing on a cruise ends the day it goes in.
The tank ships without fittings for the best possible reason: Ronco installs them per order, spin-weld or threaded, at whatever locations your plumbing actually requires. A tank this size usually feeds a pressure pump at one end and takes its fill at the other, with the vent looped high between them - a layout no fixed factory pattern gets right for every boat. Print the drawing below, mark your three or four ports, and check the whole scheme with the on-page fitting planner before ordering. FDA-grade polyethylene keeps all 65 gallons potable.
Built in Tustin, California by Ronco Plastics, molders of marine and RV tanks since 1974, the B292 shares our boat tanks shelf with several other 65-gallon footprints - worth comparing before you commit. For delivered cost to your dock or driveway, the freight cost estimator quotes your ZIP instantly. OneSource Plastics is an authorized Ronco Plastics dealer.
Technical drawing: download the Ronco Plastics B292 dimensional drawing - print it to plan your install and mark exactly where you want fittings located; Ronco installs spin-weld or threaded fittings to your marked spec.
