The Enduraplas THC0711WH is a 7,011-gallon, 15-degree cone bottom storage tank built for high-volume batching, mixing, and full-drain chemical handling where the contents need to empty completely toward a single low outlet. This is the no-stand configuration: the tank ships as the cone-bottom vessel by itself, so you supply or fabricate the support structure that carries a cone tank of this size. Plan that structure before the tank arrives, because a cone bottom cannot sit flat on the ground the way a vertical flat-bottom tank can.
Will it work for your application?
The tank holds 7,011 gallons, stands 139 inches in overall vessel height, and measures 142 inches across its outside envelope, so confirm your ceiling clearance and stand geometry against those numbers before you order. The 15-degree cone is the shallower of the common cone slopes, which keeps overall height down while still directing flow toward the bottom outlet for gravity discharge and easier cleanout between batches. Filled with water, the tank and contents weigh 58,472 pounds, which is simply 7,011 gallons at 8.34 pounds per gallon, so you can verify the figure yourself. Treat that number as your baseline: any product heavier than water raises the load proportionally and drives both the stand engineering and the pad rating. Use the Tank Sizing Calculator and the Tank Sizing Guide to match this capacity to your process volume and turnover rate.
Match the tank to your chemical before you buy
A cone bottom is the right shape for chemical service precisely because it drains clean, but the shape does not tell you whether the tank material suits your product. The most expensive mistake on a tank this size is ordering to capacity and dimensions alone and skipping the resin and specific-gravity check. This listing does not publish a specific-gravity rating, so before you store anything heavier than water or chemically aggressive, confirm the tank's resin and its rated specific gravity for your exact product and concentration by calling 866-418-1777. If your product's specific gravity exceeds the rating on this vessel, ask about a heavier-wall or higher-SG variant on that same call rather than forcing this tank past its limit. Cross-check your chemical against our Chemical Compatibility Database before you commit.
Fittings, gaskets, and support planning
This listing has no published fitting or gasket schedule, so confirm outlet size, bulkhead and gasket elastomer, and the cone flange spec at 866-418-1777 before ordering; the wetted materials at the outlet matter as much as the tank wall for chemical service. Because the 15-degree cone concentrates load at the cone-to-stand interface, size your stand and foundation to the full 58,472-pound water weight and multiply that figure by your product's specific gravity for the true rating. If you are new to cone-bottom support requirements, our buyer's guides walk through stand and pad considerations for smaller cone tanks that scale up in principle: the 550 Gallon 20 Degree Cone Bottom guide and the 300 Gallon 30 Degree Cone Bottom guide are good starting points, though neither matches this tank's 15-degree, no-stand, 7,011-gallon class exactly.
This tank ships LTL freight, quoted live to your ZIP code. Run your delivery address through the Freight Cost Estimator for a rate, or call 866-418-1777 to confirm fittings, color, resin, and delivery on your 7,011-gallon cone bottom before you order.
