The 132 Gallon ThinTank with Strainers (SKU PD-2901) is a slim vertical tank built for water storage where floor space is tight. At 47.24 inches tall on a compact 15.75 x 47.24 inch footprint, this ThinTanks unit tucks against a wall, into a narrow utility run, or along a garage bay where a round tank simply won't fit. It holds 132 gallons, weighs 94 pounds empty, and carries an 8-inch lid plus a single 1-inch outlet. It is listed under certifications 2282 and 2285.
Will it work for your site?
This is a 1.0 specific-gravity tank, rated for water and water-based contents at that density. Filled to 132 gallons of water, the tank plus contents reaches about 1,101 pounds, so size the pad and support structure for that fully loaded weight, not the 94-pound empty figure. Rated maximum content weight is 1,101 pounds and the service temperature ceiling is 120 F / 48 C. The narrow 15.75-inch width and tall 47.24-inch profile make it a natural fit for rainwater catchment lines, HVAC condensate aggregation, and greywater holding on rural and remote sites. If you are still deciding how many gallons your application actually needs, run the numbers through our Tank Sizing Calculator and cross-check the method in the Tank Sizing Guide before you commit to a footprint.
Set it on the right base
A tall, slim tank puts a concentrated load on a small footprint, so the pad matters more here than on a squat tank. A full ThinTank exerts its 1,101-pound load across roughly 15.75 x 47.24 inches, and that base must be flat, level, and continuously supported. Our guide on concrete pad sizing for above-ground polyethylene tanks walks through the ACI 360R-10 framework for getting that base right. If this tank is part of a rainwater or reuse train, the industrial water reuse tank topology guide and our first-flush diverter sizing notes cover how it sequences into a larger system.
The mistake to avoid
The most common error with a slim vertical tank is treating the 1.0 specific-gravity rating as a suggestion. This tank is built for water at that density; do not fill it with a heavier liquid or a chemical whose specific gravity exceeds 1.0 without stepping up to a higher-rated tank, because the wall was not designed for that hydrostatic load. Keep contents at or below 120 F / 48 C. Outlet fittings and gaskets are not specified in this listing, so confirm that the 8-inch lid and 1-inch outlet match your inlet and draw hardware before you order. Check the technical drawing on this page for exact port placement and overall dimensions.
This ThinTank ships LTL freight from Texas, quoted live to your ZIP code through the Freight Cost Estimator. To match the 132 gallon ThinTank to your site, confirm outlet fittings, or lock in freight before you order, call 866-418-1777.
