On a lot of coaches the dump valve hangs outboard, just inside the skirt - and feeding it from an end-dump tank means a rigid elbow that traps waste and eventually leaks. The 61H is molded for that layout: a 42-gallon gray/black tank with its dump on the side, so the termination run goes straight out. The pan measures 45 x 24.5 x 12 inches.
It is the largest of Ronco's side-dump holding moldings, above the 35-gallon 4H at 53.75 x 25 x 8 inches and the 34-gallon 20H at 63 x 20.25 x 8.5 inches. If end dump suits your plumbing better, the same capacity comes as the 21H and 74H; the whole bench is at RV holding tanks.
Construction is Ronco standard: one seamless rotomolded polyethylene piece, 32 lb blank, roughly 350 lb loaded, molded in Tustin, California by the shop that has been at it since 1974. The side dump is part of the mold; everything else - vent, inlets, rinse fitting - is installed per order to your marks. Print the drawing below, mark your fitting locations, and it ships plumbed for your coach. Waste service only.
OneSource Plastics is an authorized Ronco Plastics dealer.
Technical drawing: download the Ronco Plastics 61H dimensional drawing - print it to plan your install and mark exactly where you want fittings located; Ronco installs spin-weld or threaded fittings to your marked spec.
Freight
LTL freight is quoted to your ZIP with the freight cost estimator or by phone at 866-418-1777. The listed price is before freight.
See this tank
Interactive 3D model with live fill. This tank has an interactive 3D model built to its manufacturer dimensions. Rotate it, and set a fill level to see how much liquid it holds at any height. Open the 3D view on the product photo above. Download the 3D model (GLB).
Ready to order?
Add it to your cart at the top of this page, get LTL freight to your ZIP, request a written quote, or call 866-418-1777. The listed price is before freight.
