The 35H is a pancake: 9 gallons of holding capacity rolled out to 29.75 x 22.5 inches but standing just 8 inches tall. Ronco Plastics draws it this way for underfloor waste service where the frame gives you area but almost no depth - the classic low-clearance gray-tank problem.
It is waste-only equipment, gray or black water, with no potable rating; the fresh side of your system shops elsewhere. A 16 lb molding carrying about 75 lb when full, the one-piece rotomolded shell takes road shock without seams to fail, and the wide flat base spreads the load across the mounting surface.
Fittings go in at the factory, to your order - Ronco has molded and fitted these tanks in Tustin, California since 1974, spin-weld or threaded, at whatever locations you mark. Print the drawing below and mark your fitting locations so the plumbing lands where your runs are. Close alternatives: the 9-gallon 36H at 30 x 12.5 x 7.25 inches is narrower and lower still, and the 10-gallon 59H at 28 x 14.5 x 11 inches adds a gallon in a deeper box. Everything else is under RV holding tanks.
OneSource Plastics is an authorized Ronco Plastics dealer.
Technical drawing: download the Ronco Plastics 35H dimensional drawing - print it to plan your install and mark exactly where you want fittings located; Ronco installs spin-weld or threaded fittings to your marked spec.
Freight
LTL freight is quoted to your ZIP with the freight cost estimator or by phone at 866-418-1777. The listed price is before freight.
Ready to order?
Add it to your cart at the top of this page, get LTL freight to your ZIP, request a written quote, or call 866-418-1777. The listed price is before freight.
