The 97-1810 Rebar Cap is impalement-protection equipment sized to fit exposed vertical rebar on your jobsite. Finished in high-visibility orange with a 3.5"W x 3.5"H top face, this single unit slips over rebar sizes #3 through #8 (3/8" to 7/8" diameter) and shields workers from the injury risk of falling onto unguarded protruding steel.
Built for impalement protection
Exposed rebar is one of the most cited fall-and-impalement hazards on any concrete or foundation site. This cap presents a broad, brightly colored bearing surface over the sharp end of the bar, making the hazard both physically covered and visually obvious to crews moving through the work zone.
Specifications
- SKU: 97-1810
- Type: Rebar cap (single unit)
- Color: Orange, high-visibility
- Top face: 3.5"W x 3.5"H
- Fits rebar: #3 through #8 (3/8" to 7/8" diameter)
- Compliance: CAL-OSHA
- Function: Impalement protection
- Also available 100 per pack
Where it is used
Standard on foundation pours, retaining walls, bridge and highway work, and any site with vertical rebar dowels left exposed between phases. Fleet, facility, and safety managers keep these on hand to meet CAL-OSHA impalement-protection requirements throughout a project.
Need a full case or a freight quote to your ZIP? Call OneSource Plastics at 866-418-1777.
Freight
LTL freight is quoted to your ZIP with the freight cost estimator or by phone at 866-418-1777. The listed price is before freight.
Ready to order?
Add it to your cart at the top of this page, get LTL freight to your ZIP, request a written quote, or call 866-418-1777. The listed price is before freight.
