The 102H comes from the newest chapter of Ronco's tooling - the 100-series molds - applied to the oldest job in the catalog: 20 gallons of waste holding. Later-generation molds reflect what five decades of field returns taught the Tustin, California shop about where holding tanks actually fail: radiused corners, refined wall distribution, cleaner flat faces for fitting placement.
In the hand it is a 19 lb blank; in service it carries about 167 lb of gray or black water. It shares its capacity with a long roster of siblings, so the choice usually comes down to which drawing matches your bay and plumbing side - print the drawing below, compare, and mark your fitting locations for spin-weld or threaded installation at the plant.
Cross-shop it against the 65H, the lightest of the 20-gallon blanks, and the 13H, the standard body; from the same new-tooling series at another size there is the 104H at 15 gallons. The full waste range is in the RV holding tanks category.
Waste water only - never plumb an H-series tank to fresh supply. Rotomolded by Ronco, in continuous operation since 1974. OneSource Plastics is an authorized Ronco Plastics dealer.
Technical drawing: download the Ronco Plastics 102H dimensional drawing - print it to plan your install and mark exactly where you want fittings located; Ronco installs spin-weld or threaded fittings to your marked spec.
Freight
LTL freight is quoted to your ZIP with the freight cost estimator or by phone at 866-418-1777. The listed price is before freight.
See this tank
Interactive 3D model with live fill. This tank has an interactive 3D model built to its manufacturer dimensions. Rotate it, and set a fill level to see how much liquid it holds at any height. Open the 3D view on the product photo above. Download the 3D model (GLB).
Ready to order?
Add it to your cart at the top of this page, get LTL freight to your ZIP, request a written quote, or call 866-418-1777. The listed price is before freight.
