The Norwesco 35 Gal Inductor Tank Steel Stand is a painted steel stand built for a 35 gallon cone bottom inductor tank with a 45-degree cone. It stands 44 inches tall on a 29 x 29 inch footprint and weighs 23 lb, elevating the tank so the sloped cone bottom clears the floor and can drain down into downstream equipment.
Fit and Installation
A cone bottom tank cannot stand on its own — a correctly sized stand is a required companion, not an optional add-on. This stand is matched to the 35 gallon inductor size and 45-degree cone angle, so the tank seats into the frame with the cone supported at the proper angle. Set the stand on a firm, level surface before seating the tank, and confirm the assembly sits plumb before putting it in service.
Material Note
The frame is painted steel. Paint slows corrosion but is not a galvanized or stainless finish, so for permanent outdoor or wet-environment placement, inspect the coating periodically and touch up scratches before rust can start at bare metal.
This stand ships from the nearest of Norwesco's plants — including Chowchilla CA, Griffin GA, Houston TX, Lancaster OH, Owego NY, Shawnee OK, Sheldon IA, St. Bonifacius MN, Tooele UT, and Washougal WA — with freight quoted live to your ZIP via the Freight Cost Estimator, or call 866-418-1777. Small stands like this may also ride along with a tank order.
Freight and documents
LTL freight is quoted to your ZIP with the freight cost estimator or by phone at 866-418-1777. The listed price is before freight.
Technical drawing (PDF) for Norwesco 65517.
See this tank
Product video. Watch the Norwesco 35 Gal Inductor Tank Steel Stand video (61 seconds) with dimensions, fittings and shipping notes.
Ready to order?
Add it to your cart at the top of this page, get LTL freight to your ZIP, request a written quote, or call 866-418-1777. The listed price is before freight.
