Snyder's low stand for a 30 inch tank, with 12 inches of clearance underneath
Part number 1690000N97601 is a Snyder Industries tank stand for a 30 inch diameter tank, lifting it 12 inches off the floor. The stand is 30 inches long, 30 inches wide and 12 inches tall, and weighs 36 lb, light enough to ship by UPS. It is the low version of Snyder's 30 inch stand: a foot of clearance is enough for a bottom outlet, a valve and a hose, and it keeps the lid of the tank six inches lower than the taller version, which matters when the tank is filled by hand or stands under a shelf or a roof. If you need to get a drum or a pump under the outlet, the taller stand is the better buy.
Which Snyder tank is it going under? Call 866-418-1777 with the tank part number and we confirm the pairing before it ships, or get shipping to your ZIP and add it to your cart above.
What to check before you buy
- The tank diameter. 30 inches. It is on the tank's own page. A stand sized for a 30 inch tank carries a 30 inch tank and nothing wider.
- The clearance. 12 inches. Measure the outlet fitting, the valve and the hose or pipe leaving it, and add room for a wrench. If that stack is more than a foot, take the taller version instead.
- The total height. The stand is 12 inches tall. Add the tank height from its page and check the lid height against the person or the hose that will fill it.
- The floor. A flat, level, continuous 30 inch square with no drain, slope or slab joint under any leg.
- Anchoring. No anchor hardware is listed with the stand. If your site needs it bolted down, that hardware and the pad are yours to specify.
Snyder's drawing for this stand is linked on this page under Technical Drawing. It is the source for the leg layout, the material and the ring dimensions.
Setting it up
Set the stand where it will live and level it across both diagonals before the tank goes on. Set the empty tank, turn it so the outlet points where the valve will be easiest to reach, and fit the valve before the first fill. Fill with water the first time so any problem shows up with something harmless in the tank. Support the pipe or hose leaving the valve on its own; the outlet should carry liquid, not hardware.
Shipping
The stand ships by UPS, 30 by 30 by 12 inches and 36 lb, under NMFC 156600, from Snyder's Marked Tree, Arkansas plant. The listed price is before freight; the freight cost estimator gives the cost to your ZIP. If the tank it carries ships by truck, order both together and tell us; we arrange them to arrive on the same day. When it arrives, check the part number 1690000N97601 on the label and look at each foot before a tank goes on it.
Freight and documents
LTL freight is quoted to your ZIP with the freight cost estimator or by phone at 866-418-1777. The listed price is before freight.
Technical drawing (PDF) for Snyder Industries 1690000N97601.
See this tank
Product video. Watch the Snyder Industries 30'' diameter stand - 12'' Clearance video (65 seconds) with dimensions, fittings and shipping notes.
Ready to order?
Add it to your cart at the top of this page, get LTL freight to your ZIP, request a written quote, or call 866-418-1777. The listed price is before freight.
