Snyder's stand for a 30 inch tank, with 18 inches of clearance underneath
Part number 1690001N97601 is a Snyder Industries tank stand, named the way Snyder names all of them: by the tank it carries, 30 inches in diameter, and by the clearance it gives, 18 inches between the floor and the bottom of the tank. The stand itself is 30 inches long, 30 inches wide and 40 inches tall, and weighs 42 lb. Eighteen inches under the tank is room for a bottom outlet, a full-port valve and a hose or pipe leaving it, with a hand and a wrench still able to get in. The tank diameter is the figure to match when you order: a stand sized for a 30 inch tank carries a 30 inch tank and nothing wider.
Which Snyder tank is it going under? Call 866-418-1777 with the tank part number and we confirm the pairing before it ships, or get freight to your ZIP and add it to your cart above.
What to check before you buy
- The tank diameter. 30 inches. It is on the tank's own page. If your tank is a different diameter, this is the wrong stand, even if the clearance is right.
- The clearance you need. 18 inches here. Measure the valve, the fitting stack and whatever has to sit under the outlet, and add room to swing a wrench. Snyder makes the same 30 inch stand with less clearance if you do not need the height.
- The total height. The stand is 40 inches tall. Add the tank height from its own page and check the lid height against your ceiling and your fill point.
- The floor. A flat, level, continuous 30 inch square with no drain, slope or slab joint under it. No anchor hardware is listed; if the site needs it bolted down, that hardware is yours.
Snyder's drawing for this stand is linked on this page under Technical Drawing. It is the source for the leg layout, the material and the ring dimensions.
Setting it up
Level the stand across both diagonals before the tank goes on; a stand that rocks puts the whole load on two feet. Set the empty tank, turn it so the outlet points where the pipe will run, fit the valve, and fill with water the first time. Support the pipe leaving the outlet on its own so the tank wall carries liquid, not hardware.
Shipping
The stand ships LTL on a pallet, 30 by 30 by 40 inches and 50 lb packed, under NMFC 156600, from Snyder's Marked Tree, Arkansas plant. The listed price is before freight; the freight cost estimator gives the lane cost to your ZIP. Order it on the same ticket as the tank and the two travel together. At the tailgate, check the part number 1690001N97601 against the bill of lading and look at every foot for transit damage before the driver leaves.
Freight and documents
LTL freight is quoted to your ZIP with the freight cost estimator or by phone at 866-418-1777. The listed price is before freight.
Technical drawing (PDF) for Snyder Industries 1690001N97601.
See this tank
Product video. Watch the Snyder Industries 30'' diameter stand - 18'' Clearance video (60 seconds) with dimensions, fittings and shipping notes.
Ready to order?
Add it to your cart at the top of this page, get LTL freight to your ZIP, request a written quote, or call 866-418-1777. The listed price is before freight.
