Snyder's stand for a 36 inch tank, with 18 inches of clearance underneath
Part number 1730001N97601 is a Snyder Industries tank stand for a 36 inch diameter tank, giving 18 inches of clearance between the floor and the bottom of the tank. The stand is 36 inches long, 36 inches wide and 36 inches tall, and weighs 50 lb. Eighteen inches under the tank is enough room for a bottom outlet, a full-port valve, the hose or pipe leaving it, and a hand with a wrench, with a drum or a pump inlet still able to sit under the valve. The 36 inch tank diameter is the figure to match when you order; a stand carries the tank it is sized for and nothing wider.
Which Snyder tank is it going under? Call 866-418-1777 with the tank part number and we confirm the pairing before it ships, or get freight to your ZIP and add it to your cart above.
What to check before you buy
- The tank diameter. 36 inches. It is on the tank's own page. If your tank is a different diameter, this is the wrong stand even if the clearance suits you.
- The clearance. 18 inches. Measure the outlet fitting, the valve and whatever has to sit under it, and add room to swing a wrench.
- The total height. The stand is 36 inches tall. Add the tank height from its own page and check the lid height against your ceiling, your fill hose and the ladder you will use.
- The floor. A flat, level, continuous 36 inch square with no drain, slope or slab joint under any leg. A stand on a floor that falls toward a drain sits on three feet instead of four.
Snyder's drawing for this stand is linked on this page under Technical Drawing. It is the source for the leg layout, the material and the ring dimensions.
Setting it up
Level the stand across both diagonals before the tank goes on. Set the empty tank, turn it so the outlet points where the pipe will run, fit the valve, and fill with water the first time. Support the first length of pipe on its own; the outlet should carry liquid, not plumbing. No anchor hardware is listed; bolting down and the floor rating are for your installer.
Shipping
The stand ships LTL on a pallet, 36 by 36 by 36 inches and 50 lb, from Snyder's Marked Tree, Arkansas plant. The listed price is before freight; the freight cost estimator gives the lane cost to your ZIP. Order it with the tank and the two arrive on one truck. At the tailgate, check the part number 1730001N97601 against the bill of lading and look at each foot for a transit knock before the driver leaves.
Freight and documents
LTL freight is quoted to your ZIP with the freight cost estimator or by phone at 866-418-1777. The listed price is before freight.
Technical drawing (PDF) for Snyder Industries 1730001N97601.
See this tank
Product video. Watch the Snyder Industries 36'' diameter stand - 18'' Clearance video (60 seconds) with dimensions, fittings and shipping notes.
Ready to order?
Add it to your cart at the top of this page, get LTL freight to your ZIP, request a written quote, or call 866-418-1777. The listed price is before freight.
