The 93-2220 is the kit that turns a Todd blank molding into a holding tank: a straight pipe-to-hose adapter set with two 1-1/2 inch fittings and one 1/2 inch fitting, threading directly into the tank's molded female NPT ports. Todd ships every tank with its four ports plugged - this kit is the holding-service configuration, sized for a waste inlet, a dump line, and a vent.
Straight adapters suit installs where the hose runs leave the tank in line with the port - under-bunk and open-bilge layouts where nothing forces an immediate turn. If your run has to elbow the moment it leaves the tank, use the 90 degree version, the 93-2221, instead; same fitting complement, turned.
All connections are hose barb - flexible hose only, since rigid pipe voids Todd's warranty. One kit configures one tank for gray or black water service. OneSource Plastics is an authorized Todd dealer.
Freight
LTL freight is quoted to your ZIP with the freight cost estimator or by phone at 866-418-1777. The listed price is before freight.
Ready to order?
Add it to your cart at the top of this page, get LTL freight to your ZIP, request a written quote, or call 866-418-1777. The listed price is before freight.
