Ronco Plastics RV52W - 32 Gallon Plastic RV Water Tank (60.0" x 16.0" x 8.0")

Five feet of water tank, sixteen inches wide: the RV52W runs 60 x 16 x 8 inches, the longest and narrowest way Ronco packages 32 gallons of fresh water. This is the tank for the frame-rail run, the basement slot beside the chassis member, the long shallow void under a slide floor, spaces where capacity is available only if you can stretch it thin. At 8 inches tall it ducks under nearly everything.

Potable duty is the point of the W series: FDA-compliant natural polyethylene, translucent so the water line reads through the wall. The molding weighs about 69 pounds empty, and a full load is roughly 267 pounds at 8.34 pounds per gallon, distributed along the whole five-foot length; strap and support it at intervals, because a span this long should never carry its water unsupported in the middle.

If the proportions are wrong, the RV69W holds the same 32 gallons at 48 x 20 x 8 and the RV26W condenses it to 31 x 23 x 11.5; see the family at RV water tanks and the Ronco hub. One Source Plastics is an authorized Ronco Plastics dealer.

Standard fitting package

Choose the standard fitting package for $30 and we install these three fittings before the tank ships:

Want to place the fittings yourself? Choose the blank tank: it ships with no fittings at no charge. Add the 90-2218 fitting kit ($55.75). It includes an access plate with six stainless steel screws, washers and nuts to mount it, a 1-1/2" NPT plug, two 1/2" NPT plugs, two 5/8" thru-hull fittings for supply and vent, and one 1-1/2" thru-hull fitting for fill.

Technical drawing: download the Ronco Plastics RV52W dimensional drawing - print it to plan your install. Choose the standard fitting package (shown in the fitting layout image), or order the tank blank and place your own fittings.