Ronco Plastics RV34W - 35 Gallon Plastic RV Water Tank (33.5" x 19.0" x 16.0")

At 16 inches tall, the RV34W is the deepest of Ronco's 35-gallon fresh water moldings - a compact 33.5 x 19 inch footprint that goes vertical instead of sprawling. That geometry suits van conversions and truck campers where floor area is precious but there is height to spare under a bench seat or behind a wheel well.

Ronco's sheet lists it as the 34W L.D.: light-duty, natural FDA-compliant polyethylene, translucent enough to read the water level through the wall. This is genuinely potable-rated material - the same resin discipline that separates Ronco's fresh line from its gray-and-black holding tanks, which get waste-duty resin and no potable claim.

Full, this tank holds about 292 lb of water (35 gallons at 8.34 lb each), so mount it over structure, not just floor skin; empty, it is an 18 lb shell you can position one-handed. If your cavity is longer and shallower, look at the RV2W, 35 gallons at 37.5 x 19 x 12 inches, or step up to the 36-gallon RV7W at 30 x 22 x 14 inches. Fittings are installed per order in Tustin, California - spin-welded or threaded to your marks, so print the drawing below and mark your fitting locations before checkout. Ronco has molded tanks this way since 1974.

OneSource Plastics is an authorized Ronco Plastics dealer.

Technical drawing: download the Ronco Plastics RV34W dimensional drawing - print it to plan your install and mark exactly where you want fittings located; Ronco installs spin-weld or threaded fittings to your marked spec.