The Enduraplas 7011 gallon beige vertical water storage tank is built for sites that need serious bulk water capacity in a single footprint - rural fire reserves, agricultural supply, municipal backup, and industrial process water. It stands 126 inches tall on a 144-inch diameter and holds 7,011 gallons in one upright vessel. With large-format vertical storage like this, the two decisions that drive your whole install are the pad and the freight; the specs on this page answer the rest.
Quick specs
- Capacity: 7,011 gallons
- Height: 126 in
- Diameter: 144 in
- Footprint: 144 x 144 in
- Material: Polyethylene
- Specific gravity rating: 1.1
- Color: Beige
- Ships from: Converse, TX
Will this tank work for your site?
The tank is molded from polyethylene with a specific gravity rating of 1.1, which means it is engineered for water and water-like liquids up to that density. Filled with water, the contents weigh 58,472 pounds, and the tank carries a maximum rated contents weight of 64,319 pounds. That roughly 5,847-pound gap - about 10 percent - is exactly the margin the 1.1 SG rating buys you over plain water, and it is the number a careful engineer checks when sizing the base. For a water build, plan around the 58,472-pound water figure. At nearly 30 tons of full-load weight on a 144 x 144 inch footprint, this is not a tank you set on bare soil. The load demands an engineered, level pad sized to carry it. Our Concrete Pad Sizing for Above-Ground Polyethylene Tanks guide walks through the ACI 360R-10 framework and where the ACI 318 boundary sits, so your pad is matched to this tank's actual loaded weight rather than a rule of thumb.
Sizing, fittings, and commissioning
If you are still confirming that 7,011 gallons is the right size for your draw rate and storage duration, run the numbers with our Tank Sizing Calculator and read the Tank Sizing Guide before you commit to a footprint this large. For fire-protection reserves, the Fire-Water Reservoir Tank Design guide covers NFPA 22 sizing discipline and freeze-protection engineering for cold-climate service. If you are aggregating grey water, rainwater, or HVAC condensate into a storage train, the Industrial Water Reuse Tank Topology guide shows how a vertical storage tank like this one fits a reuse-capable architecture. Fitting and outlet configuration is confirmed per order - call 866-418-1777 or use the estimator contact and we will confirm the exact arrangement for your install. Once the tank is set, do not skip a proper fill test: our Hydrostatic Test Methodology guide covers water-fill discipline, pad-settlement monitoring, and fitting leak detection during acceptance.
The mistake to avoid
The most common error on a tank this size is treating it like a small poly tank and skipping the engineered pad. At 64,319 pounds maximum rated load, an under-built or out-of-level base will stress the tank wall and void your install. Size the pad to the loaded weight, confirm it is dead level, and fill in stages while monitoring for settlement. The second mistake is matching only the SG rating: this beige tank is rated to 1.1 specific gravity, so it suits water storage and water-density liquids. Storing a liquid denser than water? Call 866-418-1777 and we will match you to a higher-SG-rated tank rather than overload this one.
This vertical water storage tank ships LTL from the Enduraplas plant in Converse, TX, with freight quoted live to your ZIP code - never bundled into the list price. Because of its size and footprint, it moves as an oversized LTL load, so get an exact number before you order using our Freight Cost Estimator or call our team at 866-418-1777. We will help you confirm sizing, pad requirements, and delivery access for the 7011 gallon beige Enduraplas water storage tank.
