The Snyder Industries 30 Gallon HDLPE Commercial Pest Control Operator Tank is a compact, portable white tank built for pest control operators, sprayer rigs, and tight-footprint chemical transport where 30 gallons of working capacity has to ride on a truck bed or skid. Molded from High Density Linear Polyethylene with a 1.5 specific gravity rating, this is the white 30 gallon Snyder tank operators reach for when they need a rugged, manageable vessel sized to fit and stay put. At 23 inches tall on a 19 x 25 inch footprint, it drops into a service bed without eating the space you need for hoses, reels, and equipment.
Will it work for your job
The numbers that matter for sizing and mounting: 25 inch length, 19 inch width, 23 inch height, on a 19.0 x 25.0 inch footprint. Filled with water, this 30 gal tank carries roughly 250 lbs. Its 1.5 specific gravity rating raises the maximum rated contents weight to 375 lbs (250 lbs x 1.5), so it is built to hold liquids heavier than water up to that ceiling. That SG headroom is the reason operators pick this style of tank for heavier mixed solutions instead of a basic water-grade tank. Check your own mix the same way the rating is set: gallons x 8.34 x specific gravity. As long as that figure stays at or under 375 lbs, you are inside spec; if your solution runs heavier than 1.5 SG, step up to a higher-rated tank, run the volume through the Tank Sizing Calculator, or call us before ordering. Confirm both the 375 lb maximum and the 250 lb full-water reference against your bed or skid mount rating, plus the weight of the tank itself, before you load. For tank-to-application matching, the Tank Sizing Guide walks through it.
Fittings and mounting
See the technical drawing on this page for the exact fitting locations and port detail. Fitting sizes and gasketed port detail are not published in this listing, so confirm fill, draw, and vent locations off the drawing before you order pumps, cam-locks, or bulkhead fittings, and lay out your plumbing, pump, and tie-down plan off the drawing and the published dimensions above. The portable form factor and modest 250 lb full-water weight make this 30 gallon tank straightforward for a single operator to position, secure, and service.
Freight and ordering
This tank ships LTL freight from the nearest Snyder Industries plant in our network: Chowchilla, CA, Lincoln, NE, or Philippi, WV. Freight is rated by distance and destination, so it is quoted live to your ZIP rather than rolled into the list price; the estimator returns the rate from whichever plant actually services your destination and confirms the shipping mode for this 30 gallon tank. Get an exact number with the Freight Cost Estimator, or call 866-418-1777 and our team will pull the rate from the closest plant and walk you through mounting and outfitting this white 30 gal tank for your operation.
