Snyder's seismic steel stand for 3900 to 4400 gallon cone bottom tanks
Part number 79800000 is Snyder's seismic stand for its 3900 to 4400 gallon cone bottom tanks, a painted steel frame 90 inches square at the floor and 45 inches tall, weighing 2000 lb. A cone bottom tank has no flat base and needs a stand that cradles the cone and lifts the outlet high enough to work under. Seismic is the difference from Snyder's standard stand: this is the version for sites where the tank must be anchored against earthquake loads, a heavy frame built to be bolted down. Full, a 4400 gallon tank holds 36,696 lb of water before the tank and stand are counted, so the pad under it is engineered work.
Two ways to buy. Add it to your cart at the top of this page, get LTL freight to your ZIP, or call 866-418-1777. The listed price is before freight.
What to check before you buy
- The tank. Snyder pairs each cone bottom tank with a specific stand, and this one covers the 3900 to 4400 gallon sizes. Tell us the tank part number and we confirm the pair before it ships; our cone bottom tank stand compatibility matrix lays out which stand goes with which tank.
- The anchoring. A seismic stand earns its name only when it is anchored. The anchor bolts, the pad and the stamped calculation for your zone come from your engineer; Snyder's drawing, linked on this page under Technical Drawing, has the geometry they need.
- The floor. A flat, level, continuous 90 inch square of structural concrete, with no drain, joint or slope under it.
- The height. With the tank in it, the cone outlet sits 45 inches up. That decides what fits underneath: a valve and a hose, a drum, a pump inlet, a mixer. Measure that equipment before the order, not after.
Setting it up
A 2000 lb frame goes on the pad with a forklift or a crane, not a pallet jack. Set it in its final position, level it across both diagonals, then anchor it before the tank goes in. Set the empty tank, turn it so the outlet points where the pipe will run, fit the outlet valve, and fill with water the first time so any problem shows up with something harmless in the tank.
Shipping and receiving
The stand ships by LTL freight, 90 by 90 by 45 inches and 2000 lb, from Snyder's plant in Lincoln, Nebraska. The listed price is before freight; the freight cost estimator gives the lane cost to your ZIP, and a stand ordered with its tank travels with the tank. You need a forklift at the receiving end. At the tailgate, check the part number against 79800000 on the bill of lading and look at every foot and weld before the driver leaves.
Questions before you order? Call 866-418-1777 with the tank part number and your seismic zone.
Freight and documents
Ships from: Lincoln, NE. LTL freight is quoted to your ZIP with the freight cost estimator or by phone at 866-418-1777. The listed price is before freight.
Technical drawing (PDF) for Snyder Industries 79800000.
See this tank
Product video. Watch the Snyder Industries Seismic stand for 3900-4400 Gallon Cone Bottom video (63 seconds) with dimensions, fittings and shipping notes.
Ready to order?
Add it to your cart at the top of this page, get LTL freight to your ZIP, or call 866-418-1777. The listed price is before freight.
