A 1000 gallon blue Bruiser two compartment underground tank with gaskets and tees, built for Canadian installations
The Norwesco 1000 gallon two compartment Bruiser multi-use underground tank, part number 44498, is a blue polyethylene tank 102 inches long, 60 inches wide and 63 inches tall, weighing about 388 lb empty. Bruiser is Norwesco's blue multi-use underground line: the same tank works as a septic tank, a pump or holding tank, or a buried cistern, and it is a heavier build than the yellow septic tank of the same size. Two compartments means a wall inside divides it into a settling chamber and a clarifying chamber. The part number means it arrives ready to plumb: a 4 inch gasketed PVC tee assembly at the inlet and at the outlet, the gaskets, and two covers for the 20 inch gasketed manways, one over each chamber. The pipe pushes into a gasket at each end instead of being solvent welded to an adapter. It is the version Norwesco lists for Canada. Norwesco lists the tank as IAPMO approved, and the service limit is 130 F.
Does your jurisdiction accept it? Call 866-418-1777 with the permit requirements, get freight to your ZIP and add it to your cart above, or request a written quote.
The jobs it does
As a septic tank the house drain enters through the inlet tee, solids settle in the first chamber, and clarified effluent leaves through the outlet tee for the drainfield. As a pump or holding tank it holds effluent between pump cycles. As a cistern it stores rainwater, hauled water or a fire reserve; 1000 gallons of water weighs 8340 lb, which is the load the bedding carries when the tank is full. For a fire reserve, read our guide to fire water reservoir design for rural and remote sites. If the water is for drinking, tell us before you order and we will confirm the right tank for that. For a Canadian site, our guide to Norwesco IAPMO and CSA B66 septic tank approvals explains how Norwesco's Canadian approval differs from the US listings; read it before buying this part number for a site south of the border. For the volume, use the tank sizing calculator and tank sizing guide.
What comes with it, and what to check
- Tees and gaskets. A 4 inch gasketed PVC tee assembly at the inlet and at the outlet, with the gaskets, for 4 inch drain pipe. The inlet tee turns the incoming flow down below the scum layer; the outlet tee draws from the clear zone. Keep the gaskets clean and dry until the plumber arrives.
- Manholes. Two 20 inch gasketed manways, both covers included. Gasketed lids keep groundwater out and septic gas in. If the lids will finish below grade, Norwesco's riser and extension options for this shell are listed under Riser and Extension Options on this page; measure from the tank top to finished grade before you order.
- The hole. 102 inches long and 60 inches wide, plus room around it for bedding and compaction. The 63 inch height plus the cover your code requires sets the depth, and that depth has to work with the elevation of the sewer line leaving the house.
- Groundwater. An empty polyethylene tank in wet ground floats. Follow Norwesco's installation instructions on bedding, backfill and filling, and never leave the tank pumped empty when the water table is high.
The same shell and sizes nearby
Related tanks: the 1000 gallon multi-use underground tank for Canada, part 41736; the 1000 gallon yellow two compartment septic tank for Canada, part 41724; the 1250 gallon Bruiser multi-use septic tank for Canada, part 41754. Each page carries its own dimensions and approvals. Match the part number to your permit, not the gallons.
Shipping, receiving and setting
The tank ships LTL from the nearest of Norwesco's St. Bonifacius, Minnesota; Owego, New York; Lancaster, Ohio or Washougal, Washington plants, 102 by 60 by 63 inches on the truck. The listed price is before freight; the freight cost estimator gives the lane cost to your ZIP. Have a machine on site to lift it. At the tailgate, check 44498 on the bill of lading against the moulded number, count both manhole covers and both tee assemblies, and walk the shell for transit damage before you sign. Set it on the bedding Norwesco's installation instructions call for, and fill it with water as you backfill so the walls stay round; 1000 gallons of water weighs 8340 lb. Keep vehicles off the ground above it.
Questions before you order? Call 866-418-1777 with the permit in hand.
Freight and documents
Ships from: St. Bonifacius, MN; Owego, NY; Lancaster, OH; Washougal, WA. LTL freight is quoted to your ZIP with the freight cost estimator or by phone at 866-418-1777. The listed price is before freight.
Technical drawing (PDF) for Norwesco 44498.
Ready to order?
Add it to your cart at the top of this page, get LTL freight to your ZIP, request a written quote, or call 866-418-1777. The listed price is before freight.
