The Enduraplas TLV10000BE is a 10,000-gallon beige vertical water storage tank molded from polyethylene, built for high-volume water storage where you need real bulk capacity in a single above-ground vessel. At 178 inches tall on a 144 x 144 inch footprint, this is one of the larger vertical storage tanks in the line, and it is rated for liquids up to 1.1 specific gravity, meaning water and water-density liquids.
Will it work for your site
Start with the numbers that actually drive your install. Filled to 10,000 gallons of water, this tank carries roughly 83,400 pounds of contents, and at its 1.1 SG rating the maximum rated contents weight is about 91,740 pounds. That load is the single most important figure for planning, because it dictates your pad. A 12-foot by 12-foot footprint holding over 41 tons of water needs a properly engineered foundation, not bare ground or a patio slab. Work through our concrete pad sizing guide before you order, and confirm your intended fill height against the tank's 178-inch overall height for clearance under any roof, eave, or fill line. If you are still deciding between sizes, the Tank Sizing Calculator and Tank Sizing Guide help you match this water storage tank to your draw-down and refill cycle.
Sizing, commissioning, and use cases
A vertical storage tank at this volume tends to serve rural fire reserves, bulk water buffering, and water reuse trains where you are aggregating and banding supply. For fire-protection reserves, our fire-water reservoir design guide walks through NFPA 22 sizing discipline and cold-climate freeze protection. If you are building a grey-water, rainwater, or condensate aggregation system, the water reuse topology guide covers staging and treatment sequencing. Once the tank is set, fill it correctly: our hydrostatic test methodology guide covers water-fill discipline, pad-settlement monitoring, and the hold-time math that catches a fitting leak before it becomes a problem.
The mistake to avoid
The most expensive error on a tank this size is underbuilding the pad or skipping the staged hydrostatic fill. Forty-plus tons of water exposes any settlement, any unlevel pad, and any fitting weakness instantly. Confirm the fitting configuration on this tank for your inlet, outlet, and overflow needs before ordering, and review the technical drawing on this page for exact port placement and dimensional layout. The 1.1 SG rating is sized for water; if your service involves a heavier liquid, contact us at 866-418-1777 before you buy so we can match you to a tank rated for the higher specific gravity.
Freight
This tank ships LTL from the Enduraplas plant in Converse, TX, with freight quoted live to your ZIP code. Given its 178-inch height, 144-inch footprint, and roughly 91,740-pound rated load, it exceeds standard LTL handling and moves as a dedicated freight item that typically requires the right truck plus offload equipment and confirmed site access for placement. Use the Freight Cost Estimator for a quote to your delivery point, or call us at 866-418-1777 to arrange delivery and confirm site access for offload. We will help you plan the receiving and placement of a tank this size.
