Among Ronco Plastics' five 58-gallon fresh-water molds, the RV60W is the middle path: 44 x 22 x 15.5 inches - shorter than the rail-runner, longer than the square, at the full 15.5-inch height that maximizes volume per square inch of floor. When none of the extreme shapes quite fits, this 74 lb molding usually does.
The extremes, for comparison: the RV43W at 58 x 20 x 13 inches is the longest and lowest, the RV44W at 34 x 34 x 13 inches is the square, and the RV42W at 46.75 x 20.75 x 15.5 inches runs slightly longer at the same height. All hold the same roughly 484 lb of water when full.
Spec is the family standard: light-duty FDA-compliant natural polyethylene, translucent wall as a built-in sight gauge, one-piece seamless rotomolding from the Tustin, California plant Ronco has run since 1974. Fittings are installed per order - spin-weld or threaded - so print the drawing below and mark your fitting locations, then browse the rest of the ladder under RV water tanks.
OneSource Plastics is an authorized Ronco Plastics dealer.
Technical drawing: download the Ronco Plastics RV60W dimensional drawing - print it to plan your install and mark exactly where you want fittings located; Ronco installs spin-weld or threaded fittings to your marked spec.
Freight
LTL freight is quoted to your ZIP with the freight cost estimator or by phone at 866-418-1777. The listed price is before freight.
Ready to order?
Add it to your cart at the top of this page, get LTL freight to your ZIP, request a written quote, or call 866-418-1777. The listed price is before freight.
