The 4 Inch SCH 80 CPVC Slip Fit Siphon Tube from Snyder Industries is a Schedule 80 CPVC draw tube built for the discharge side of bulk storage and transfer systems. The tube runs 4 inches in nominal diameter, arrives in a compact 9 x 9 x 4 inch shipping carton, and weighs about 6 pounds. If you have been searching Snyder Industries tank parts for a slip-fit CPVC siphon tube, this is the SCH 80 component that lands in the delivery.
Does it work for your setup
This is a slip-fit tube in Schedule 80 CPVC, so it slides into a matching 4 inch slip connection rather than threading in. Schedule 80 is the heavier-wall stock, and CPVC gets specified here over lighter plastics because it holds up to the elevated-temperature service that lighter tube materials cannot. The 4 inch diameter sets the draw path, and the 4.0 dia figure under sizing is what you size the mating port around. Confirm your tank's bulkhead bore is set up for a 4 inch SCH 80 slip connection before you order, since a slip tube depends on a correct diameter match. The pack does not carry a temperature rating, gasket detail, or chemical certification for this part, so match it to the service conditions already engineered into your tank and piping rather than assuming a limit here.
Where it fits in the system
A siphon tube pulls product from inside the tank toward the outlet, so it works with the tank plumbing you already run. Confirm the mating bulkhead spec on your tank before ordering so the 4 inch slip fit lands cleanly. If you are still sizing the storage side, the Tank Sizing Calculator and the Tank Sizing Guide walk through capacity and drawdown before you commit to a plumbing layout. For level indication that pairs with a draw tube, our guide on sight-glass and sight-tube level indication covers material compatibility and freeze protection for outdoor tube lines.
The mistake to avoid
The common miss on a slip-fit siphon tube is treating diameter as approximate. A 4 inch SCH 80 slip tube needs a 4 inch SCH 80 mating connection; a near-size port or a threaded assumption means the tube will not seat into your bulkhead. Verify the connection type and diameter against your existing fitting first.
This siphon tube ships LTL, quoted live to your ZIP from the nearest Snyder plant among Lincoln, NE; Marked Tree, AR; Merced, CA; and Philippi, WV. Run your ZIP through the Freight Cost Estimator for a rate, or call 866-418-1777 and we will confirm the fit and the freight together.
