Add-ons and Accessories

Stand only for Norwesco 85 and 110 gallon cone bottom tanks. Sold in black, it measures 35" x 35" at the base, stands 31" tall, and weighs 63 lb. The tank is sold separately — this listing is the stand alone. What It Fits As the product name states,...

The Snyder Industries stand for 17 gallon cone bottom tanks is a steel support frame built to hold a 17 gallon cone bottom tank with a 60-degree cone. It weighs 22 lb and stands 30.13 inches tall on a compact 19 x 18.25 inch footprint, so it drops into...

The Snyder Industries 35, 65, or 110 Gallon Stand is a steel flat-bottom tank stand, not a storage tank. It raises a flat-bottom tank to a level working height so you can drain and service it off the ground. The black steel frame carries a 30 x 30 inch...

The N-65079 is a stainless steel support band from Norwesco, sized to wrap the 2650, 3135, and 3250 gallon tanks. It is a corrosion-resistant steel ring that supports the tank shell where the profile requires banding. Each band spans roughly 85.5 by 75...

This is the steel mounting band for the Norwesco 3135 and 3250 gallon elliptical leg tanks. It is a hold-down component, not a tank: a fabricated steel band that wraps the elliptical shell and secures the tank to its saddle or trailer frame so the load...

This is the steel mounting band for the Norwesco 3135 and 3250 gallon elliptical leg tanks — the hold-down hardware that secures the tank body so an elliptical leg tank rides steady under load. It is a replacement or additional band, not the tank itself...

The Norwesco Long Support Band (N-62348) is a steel support band for the Norwesco 3210 gallon drainable leg tank. As the product name states, 2 bands are required per tank — a single band is not a complete set, so order two to finish an installation...

These Norwesco steel support bands are made for the 3210 gallon drainable leg tank — and as the name states, 2 bands are required per tank, so order them as a pair. Each band is steel, 90 inches long by 2 inches wide with a 56-inch profile, and weighs 41...

The Norwesco 50 Rectangular-B is a doorway-profile polyethylene tank built for tight-access liquid storage where a round 50-gallon tank simply won't fit through a standard opening. At 41 inches long, 26 inches wide, and 15 inches tall, its low...

The 1 1/2 Inch Double Flanged Fitting is a Snyder Industries bolted tank fitting molded from CPVC, supplied with a Viton gasket and stainless-steel encapsulated bolts. As a "double flanged" bolted fitting, it seals by compression as the two flanges are...

This polyethylene stand is made for the Norwesco 175 and 310 gallon cone bottom tanks with a 30 degree cone. It has a 42" x 42" footprint, stands 32" tall, and weighs approximately 100 lb, giving these two cone bottom models a dedicated base so the...

This stand is built for the Chem-Tainer 75 or 100 gallon inductor tank, holding the cone-bottom vessel upright with clearance below the cone for full drainage. The listed cone angle is 15 degrees. The stand measures 33" x 33" at the base, stands 36"...