7000 Gallon 15 Degree Plastic Cone Bottom Tank with Stand

The Enduraplas 7000 Gallon 15 Degree Plastic Cone Bottom Tank with Stand (SKU THC07011KFG) is a large-volume cone-bottom vessel built for full-drain batching, mixing, and chemical storage where you need the tank to empty completely through the bottom rather than pool product on a flat floor. The 15-degree cone lets settled solids slide toward the outlet, which is why processors reach for a cone bottom on a poly stand over a standard vertical tank. This is a serious footprint: it stands 150 inches tall on its stand and occupies a 145.0 x 144.0 inch pad area, so plan your slab and overhead clearance before it arrives.

Will it work for your application?

At 7,000 gallons of nominal capacity, a full charge of plain water weighs 58,380 lb across the tank and stand, so your concrete pad and anchoring have to carry that load plus any product heavier than water. Use the Tank Sizing Calculator and the Tank Sizing Guide to confirm the working volume you actually need and to check your floor loading against that filled weight. The elevated cone-and-stand design keeps the discharge point up off the ground, which makes gravity draining into pumps, totes, or downstream lines straightforward. If you are cross-shopping large poly cone-bottom tanks with integrated stands, this is the size class buyers land on when a 300, 310, or 550 gallon unit is simply too small for the batch.

The mistake to avoid: confirm resin and specific gravity first

The single most common error on a cone-bottom chemical tank is committing it to a heavier-than-water product without confirming what the tank is rated for. This listing does not carry a published specific-gravity rating or a confirmed resin grade, so before you put any chemical heavier than water in it, call 866-418-1777 and have us verify the resin and the SG rating this specific tank is built to. Match your chemical's specific gravity and concentration to a rated tank rather than assuming water-weight geometry applies. Our Chemical Compatibility Database is the right first stop for pairing a resin and gasket to your fluid.

Fittings and layout: confirm before you pipe it

Outlet size, bulkhead fittings, and gasket material are not published for this SKU, so treat the hardware as build-to-confirm: resin, gasket, and outlet material should all be verified on the phone before chemical duty, not assumed. Review the technical drawing on this page for the cone angle, outlet position, and stand geometry so your piping and containment are laid out correctly the first time, and call 866-418-1777 to lock the fitting and gasket set to your product.

Freight on a 7,000 gallon cone bottom

A tank this size ships LTL freight on its own, and freight is always quoted separately to your ZIP code, never included in the list price. Run your delivery address through the Freight Cost Estimator for a live rate, or call 866-418-1777 and we will confirm transit and any offload requirements for a tank of this height and footprint. Because of the 150-inch stature and filled weight, confirm your site access, crane or forklift capacity, and pad readiness before the truck is scheduled.

Ready to move on a 7000 gallon 15 degree cone bottom tank with stand? Get your freight number from the Freight Cost Estimator or call 866-418-1777, and lean on the Chemical Compatibility Database and Tank Sizing Guide to spec it right for your product.