The Enduraplas 210 Gallon Beige Vertical Water Storage Tank is a beige, vertical water storage tank that holds 210 gallons of polyethylene-stored water on a compact 40-by-40-inch footprint and stands 48 inches tall. Built by Enduraplas and rated to a specific gravity of 1.1, it puts real bulk water capacity into a tight square of pad or floor space, with a neutral opaque tone that reads well in both outdoor and indoor settings. It suits water storage, rainwater capture, hauling, and reuse duty.
Specs at a glance
Capacity 210 gallons. Height 48 in. Footprint 40 x 40 in. Material polyethylene. Color beige. Specific gravity rating 1.1. Full of water it carries roughly 1,751 lb. Use these numbers to check the tank against your pad, doorway, and overhead clearance before you order.
Will it work for your job
This vertical storage tank is sized for sites that need volume without a sprawling footprint. Filled to 210 gallons of water it carries about 1,751 pounds, and its build is rated to a maximum contents weight of 1,927 pounds. That gap is 176 pounds of structural headroom above full water, which is exactly what the 1.1 specific gravity rating looks like expressed in pounds. The tank is sold here for water service at that 1.1 rating, so do not plan it for anything denser without confirming the application with us first. Before you fill, confirm your pad or stand is level and rated for the full loaded weight, with the entire 40-by-40-inch base fully supported, not just the perimeter. If you are weighing several volumes, run your draw and refill cycle through the Tank Sizing Calculator and the Tank Sizing Guide so you land on the right size instead of guessing high.
Fittings and plumbing
This pack does not list a fitting or outlet schedule for this tank, so confirm bulkhead and outlet sizes with us before you order rather than assuming a configuration. Match your plumbing to your pump and line size up front. Call 866-418-1777 and we will verify the outlet arrangement and walk through what your draw and fill setup needs.
Set it on the right base
An above-ground polyethylene tank lives or dies by its foundation. A full 210-gallon column concentrates almost a ton onto that 40-inch square, and any soft spot, gap, or slope under the base becomes a stress point over time. Our guide to concrete pad sizing for above-ground polyethylene tanks walks through getting the pad right within the ACI 360R-10 framework. On a new install, fill and check before you trust it: our hydrostatic test methodology guide covers water-fill discipline, pad-settlement monitoring, and fitting leak detection so the first fill doubles as your acceptance test. If this tank is going into a reuse train or a fire reserve, our references on industrial water reuse tank topology and fire-water reservoir tank design help you place it correctly.
This tank ships LTL freight from the Enduraplas plant in Converse, TX, with the rate quoted live to your ZIP code. Because it ships from a single Texas origin, your freight scales with distance to your delivery point, which is why a live number beats any estimate. Get yours in seconds with the Freight Cost Estimator, or call 866-418-1777 and we will work it out with you.
