The Enduraplas TLV10000B is a 10,000 gallon black vertical water storage tank built in polyethylene for large-volume bulk water service - rural fire reserves, irrigation supply, industrial process water, and grey-water or rainwater reuse storage where 10,000 gallons in a single vertical footprint makes sense. It stands 178 inches tall on a 144 x 144 inch footprint (12 feet square), and the black wall blocks light to suppress algae in standing water - the reason black is preferred over a translucent wall for the long-dwell stored water this tank is sold into, from a fire reserve sitting full for months to a quality-banded reuse train. Rated to a 1.1 specific gravity, it carries plain water and slightly heavier water-based contents without trouble.
Will it work for your site?
Start with the numbers, because they drive everything else about this install. Filled with water, the tank and contents weigh 83,400 lb; its rated ceiling at 1.1 specific gravity is 91,740 lb - about 8,340 lb of usable density headroom, roughly 10% above plain water. That full weight is roughly 42 tons of static load sitting on a 12-by-12-foot pad, so the foundation is not an afterthought - it is the project. A flat, level, fully supporting pad is mandatory; see Concrete Pad Sizing for Above-Ground Polyethylene Tanks for the ACI 360R-10 framework that governs a load this size. If you are still confirming whether 10,000 gallons is the right volume for your draw rate or storage days, the Tank Sizing Calculator and Tank Sizing Guide will help you size the reserve before you commit to a footprint this large. If your contents run heavier than 1.1 specific gravity, this water-rated unit is the wrong tank - step up to a higher-SG-rated Enduraplas vertical built for chemical and industrial service.
Fire-water and reuse service
A vertical storage tank of this capacity is a natural fit for a private fire-protection reservoir or an industrial water-reuse train. If this tank is feeding a rural or remote fire system, read Fire-Water Reservoir Tank Design for Rural and Remote Sites for NFPA 22 sizing discipline and cold-climate freeze protection - both matter when a 10,000 gallon poly tank is the heart of the private fire stack. For grey-water, rainwater, or HVAC condensate aggregation, the Industrial Water Reuse Tank Topology guide covers how a tank this size fits a quality-banded storage train. Fitting, bulkhead, and gasket configuration is confirmed per unit at order, so call 866-418-1777 to verify your inlet, outlet, and overflow layout before you plumb it rather than assuming it - see the technical drawing on this page for the as-built fitting positions.
The mistake to avoid
The single biggest error on a tank this large is filling it before the pad has been proven. At 83,400 lb full, any settlement, void, or out-of-level condition under the base concentrates stress on the polyethylene and can crack the wall. Fill the tank with water in controlled stages and watch the pad as you go - the Hydrostatic Test Methodology for New-Install Tank Acceptance guide walks through the water-fill discipline, settlement monitoring, and hold-time math that catch a problem at 2,000 gallons instead of 10,000. Remember the second mistake too: an empty 178-inch vertical is tall and light, so it is wind-vulnerable until filled - plan base anchoring and hold-down at the same install stage as the pad. And confirm your contents stay at or below the 1.1 specific gravity rating; this is a water tank, not a chemical tank.
This tank ships LTL from the Enduraplas plant in Converse, TX, with freight quoted live to your ZIP - get a number for your delivery point with the Freight Cost Estimator, or call 866-418-1777 to talk through delivery access for a tank this size. A 12-foot-square, roughly 15-foot-tall load needs route and overhead clearance plus a crane or large forklift staged before the truck arrives, so plan the offload before you order.
