Snyder Industries 200 Gallon Industrial HDLPE Rectangular PCO Tank 1.5 SG

Where it goes and why the weight matters

At 70 lb empty this is the lightest of the 200 gallon PCO bodies Snyder makes, and on a light truck already carrying a pump, a hose reel and a toolbox, the empty weight of the tank is one of the few payload numbers you still get to choose. The 49 by 37 inch footprint runs lengthwise in a full size bed or across a utility trailer; measure between the wheel arches and up to the underside of any rack or canopy before you order, because at 39 inches tall the lid sits above most bed rails. On the ground or on a shop floor, the tank needs flat, continuous support under the whole base. Strap over the body, never over the lid, and pull the straps down onto the base rather than pinching the wall. A rectangular tank that is part full moves its load every time the truck stops; keep it full or nearly empty on the road and brake early with a full tank. No baffles are listed, so assume the liquid moves.

What goes in it

Pest control mixes, water and the dilute chemistries polyethylene handles are the normal loads; liquids heavier than 1.5 times water need a higher rated tank. Check anything stronger than a dilute mix against our chemical compatibility guide before it goes in. Size the volume to the route before you settle on the shape with the tank sizing calculator and the tank sizing guide; 200 gallons is a working day for some routes and half a morning for others. If the tank will be a fixed fill station in the shop rather than a travelling one, our guide to laying out fill, vent, level and drain fittings on a polyethylene tank is worth reading before anyone drills, and our level gauge selection guide covers how to see the level without climbing on the truck.

Openings and what to check before you buy

1. Lid. A 10 inch lid on top, wide enough to fill from a hose and to get a hand inside.
2. Outlet. None is stated for this part. If you need a factory installed outlet, tell us the size and position you want before you order and we will confirm what Snyder supplies.
3. Drawing. Snyder's drawing for this tank is linked under Technical Drawing on this page; use it to plan the strap positions and the pump location.
4. The space. 49 inches long, 37 inches wide, 39 inches tall. Take the tape to the vehicle, not the catalogue.

Sizes nearby

Snyder makes four 200 gallon PCO bodies and they differ by an inch or two and a few pounds: the 200 gallon portable PCO tank 1660000C137, the 200 gallon PCO200 and the 200 gallon rectangular PCO tank 32149. One size down is the 150 gallon industrial rectangular PCO tank; one size up is the 325 gallon white PCO water tank. On a given truck exactly one of them may fit, so compare the dimensions on each page.

Shipping and receiving

The tank ships LTL under NMFC 156600-03 from the nearest of Snyder's plants in Chowchilla CA, Lincoln NE or Philippi WV, 49 by 37 by 39 inches at 70 lb. Add it to your cart at the top of this page, get LTL freight to your ZIP, or call 866-418-1777. The listed price is before freight; the freight cost estimator gives the lane cost to your ZIP. At the tailgate, check the part number against 1660000N43 on the bill of lading, look over every face for transit damage, and fill it with water the first time before it carries a mix.