The Snyder Industries 4650 Gallon ASTM XLPE Black Vertical Storage Tank is a heavy-duty crosslinked polyethylene bulk vertical storage tank built for high-demand water and process-water service. Molded in black crosslinked linear polyethylene (XLPE) with a 1.5 specific-gravity rating, it stands 154 inches tall on a 102 x 102 inch footprint and holds 4,650 gallons. If you are sizing a large vertical tank for fire-water reserve, rainwater capture, industrial water reuse, or bulk process water, the numbers here are the ones to design against.
Will it work for your site
Full of water this tank carries roughly 38,781 pounds, and its 1.5 SG rating means it is engineered for contents up to about 58,172 pounds of maximum rated weight. The specific-gravity number is a go/no-go check, not just a spec: it means the tank is rated to store fluids up to 1.5 times the density of water, so confirm your fluid's specific gravity is at or below 1.5 before you select it. The 102 x 102 inch footprint is what you pour your pad to. Size and reserve-volume math run cleanly through our Tank Sizing Calculator and the Tank Sizing Guide, and if this is a rural fire reservoir, our Fire-Water Reservoir Tank Design guide covers NFPA 22 sizing discipline and cold-climate freeze protection.
Fittings and access
This vertical storage tank comes configured with a flange fitting, a 12" x 13.75" S.U.M.O. flat fitting, an 18" polyethylene threaded/vented fitting, and additional S.U.M.O. and S.U.M.O. flat fittings. Tank access is through a manway with a 15" access opening. Verify that 18" threaded/vented top fitting is open and functioning before you draw the tank down; a sealed 4,650-gallon tank under draw needs that vent. Confirm exact fitting positions and elevations against the technical drawing on this page before you plumb the site, and match your bulkhead gaskets (EPDM, Viton, or Buna-N) to your specific service, because the gasket, not the tank, is the fluid-contact wear point.
Getting it to you
This is a large-footprint vertical tank, so it ships LTL freight on its own from the Snyder plant in Marked Tree, Arkansas. Freight is quoted live to your ZIP because rate depends on distance, accessorials, and delivery site; South-Central and Southeast destinations generally quote lower than West Coast off that Arkansas origin. Get a real number in minutes with our Freight Cost Estimator, or call 866-418-1777 and we will quote it for you. One mistake to avoid: pouring an undersized or off-square pad. Size the slab to the worst case, the full 58,172-pound max-rated load across the entire 102 x 102 inch footprint, not the lighter water weight. See our concrete pad sizing guide before you break ground.
