The Snyder Industries 1900 Gallon Vertical Liquid Storage Tank is built from high density linear polyethylene with a 1.5 specific gravity rating, sized for high-volume water and liquid storage where you need rated capacity in a compact footprint. It stands 147 inches tall on a 64 x 64 inch base and holds 1,900 gallons. The 64 x 64 inch footprint and 147-inch height are the two numbers to confirm against your pad and overhead clearance before you order - this is a tall vertical tank, and the technical drawing on this page shows the fitting layout and exact dimensions.
Will this tank work for your site?
This is a white vertical storage tank rated to a 1.5 specific gravity, meaning the wall is built to safely hold contents up to 1.5 times the density of water. For a water or fire-water duty (density 1.0), that 1.5 rating is margin you already own - a substantial safety factor on hoop stress for a tank carrying plain water. Filled with water the tank holds roughly 15,846 pounds; at its maximum rated contents density it carries up to 23,769 pounds. Those weights drive your pad and foundation decision, not the empty weight - run them through the Tank Sizing Calculator and review the Tank Sizing Guide to confirm the size matches your draw and refill cycle. For an above-ground install, spec the slab to the 23,769 lb max-rated figure if there is any chance of denser fill; the concrete pad sizing guide walks through the ACI framework for a tank this large.
Fittings, access, and venting
The drawing for this tank shows a flange, an 18-inch PE threaded and vented fitting, a manway with 15-inch access, and a flat fitting pad. The 15-inch manway is your inspection and clean-out port; the flat pad is an un-drilled landing for adding an outlet or bulkhead, so plan on field-fitting that connection rather than assuming an outlet ships installed. Venting is not optional on a tank this size - a fast fill or draw moves close to 1,900 gallons of air, and a capped or undersized vent can collapse or balloon the HDPE wall. Keep the 18-inch PE threaded/vented fitting unobstructed and match downstream venting to your pump fill rate. Confirm each fitting size and position against your plumbing plan, and verify the manway gasket, any flange or bulkhead gaskets, and your thread sealant are all rated for your service liquid and compatible with PE. See the technical drawing on this page for the exact fitting callouts and placement.
Sizing and inspection notes
At 1,900 gallons this Snyder vertical HDPE storage tank suits bulk water, fire-water reserves, and similar liquid duty. If you are sizing for private fire protection, the fire-water reservoir design guide covers NFPA 22 sizing discipline and freeze protection for cold-climate sites. One mistake to avoid on long-service vertical tanks: inspecting only the liquid side. Wall behavior at the vapor-saturated headspace is where premature failures often originate - the HDPE wall thickness guide explains the ASTM D1998 sizing logic operators should understand.
This tank ships LTL from the Snyder plant in Philippi, West Virginia, with freight quoted live to your ZIP. Because it is a 147-inch-tall unit, confirm site access and unloading equipment before delivery. Get an exact rate with the Freight Cost Estimator, or call us at 866-418-1777 to confirm fittings, lead time, and delivery for your site.
