Snyder Industries 210 Gallon Commercial Vertical Liquid Storage Tank

The Snyder Industries 210 Gallon Commercial Vertical Liquid Storage Tank (SKU SII-1012900C26) is a white vertical storage tank molded from high density linear polyethylene, built for liquid storage where you need a compact footprint and serious weight headroom. It stands 55 inches tall on a 36 x 36 inch footprint, holds 210 gallons nominal, and carries a 1.9 specific gravity rating, which sets the maximum density of contents the tank is structurally rated to hold. Each one is molded at the Snyder Industries plant in Philippi, West Virginia.

Will this tank work for your application?

Start with weight, because that is what loads your pad and your anchoring. Filled with water, the contents weigh about 1,751 pounds. Because this white vertical storage tank is rated to 1.9 specific gravity, the maximum rated contents weight climbs to 3,328 pounds when it holds a denser liquid up to that rating, roughly 1,577 pounds of additional contents-weight capacity above plain water before you reach the limit. Size your foundation and tie-downs to the heavier number if you ever plan to store anything denser than water. The tank stands 55 inches tall on a 36.0 x 36.0 inch footprint. If you are not certain which capacity suits your draw rate and refill cycle, run the numbers with our Tank Sizing Calculator and read the Tank Sizing Guide before you commit.

What to get right before you buy

The most common mistake on a vertical tank this size is under-building the base. A 3,328-pound rated load on a 36-inch footprint concentrates real weight on a small area, so the pad has to be flat, level, and fully supporting the entire bottom. Our guide on concrete pad sizing for above-ground polyethylene tanks walks through the ACI framework for getting that foundation right. The second thing to confirm is the specific gravity of your liquid versus the 1.9 rating: water is 1.0, and as long as your liquid sits at or below 1.9 you are inside the tank's structural design envelope. Fitting locations and dimensional detail are on the technical drawing on this page, so refer to it before you plumb your inlet and outlet.

Putting it to work

This 210 gallon size lands in a sweet spot for grey-water capture, rainwater holding, HVAC condensate aggregation, fire-water reserves, and other reuse trains where a compact vertical storage tank fits a tight equipment pad. Our deep-dive on industrial water reuse tank topology shows how a tank like this fits into quality-banded storage. If you are sizing a private fire reservoir, the fire-water reservoir design guide covers NFPA 22 sizing discipline and cold-climate freeze protection. For a full breakdown of this exact size, see our 210 Gallon Vertical Liquid Storage Tank buyer's guide.

This tank ships LTL freight only, from the Snyder Industries plant in Philippi, West Virginia, with the carrier and rate quoted live to your ZIP code (no parcel option on a tank this size). Get an exact number for your delivery with our Freight Cost Estimator, or call us at 866-418-1777 and we will work out the freight and confirm availability for your project.