The 1250 gallon two compartment low profile septic tank built in Georgia
The Norwesco 1250 gallon two compartment low profile septic tank, part number 43545, is a green polyethylene septic tank 157 inches long, 60 inches wide and 51 inches tall, weighing 445 lb empty. It comes from Norwesco's Griffin, Georgia plant, the short lane for the southeast. The internal baffle divides it into two chambers, the first settling solids and the second sending clearer liquid on to the drainfield, which is why many codes now ask for two compartments on a new system. The low profile body goes into a shallow excavation. The plumbing ships loose, a 4 inch gasket with tee assembly for the inlet and another for the outlet, fitted on site so the tees line up with the pipe runs as they are dug. Access is a 20 inch opening on top. Norwesco lists the tank as IAPMO approved, rates it to 130 F and backs it with a 5 year warranty. Full of water it holds 10425 lb.
Is this the right part number for your state? Call 866-418-1777 with the county and the system design, or get freight to your ZIP and add it to your cart above.
Which 1250 two compartment tank to order
Norwesco builds this two compartment body under several part numbers, and what separates them is the plant and the state approvals each number carries, not the tank. This one ships from Georgia; the approval list for 43545 is something we confirm for your state before the order goes in, because a tank bought on the wrong number can fail an inspection even though the body is identical. The permit comes from the county health department against the system design. A 1250 gallon tank is a common size where the code sizes on bedrooms, and our guide to single compartment versus two compartment septic tanks explains when the second chamber is required and when it is simply the better tank. Our note on Norwesco IAPMO and CSA B66 septic tank approvals covers what the listing means.
Openings, plumbing and what to check before you buy
- Inlet and outlet. A 4 inch gasket with tee assembly at each end, shipped loose. The gasket seals the pipe in the tank wall; the tee drops the inflow below the scum layer and holds solids back at the outlet. Fit them before the tank goes in the hole, the inlet tee turned to the house line and the outlet tee to the drainfield line.
- Access. A 20 inch opening on top for pumping and inspection. If the burial puts it below grade, a riser brings the lid up; tell us the depth and we quote one with the tank.
- Pipe falls. The inlet sits higher than the outlet, so the house line and the drainfield line are set to the tank. Our tank plumbing walkthrough covers the tie in.
- Drawing. Norwesco's drawing for this tank is linked under Technical Drawing on this page and gives the inlet and outlet heights and the baffle position.
Setting it
Follow Norwesco's installation instructions and the conditions on your permit. Dig to the drawing, bed the tank on a level, rock free base, fill it with water as you backfill so the walls are supported from both sides, and keep vehicles off the area for good. In wet ground an empty tank wants to float, so do not leave it empty in an open hole overnight. Have the inspector see the tank set and the plumbing connected before the backfill covers it.
Related tanks
The broadly approved build of the same two compartment loose plumbing tank: the 1250 gallon two compartment tank, 43503. The same tank with the plumbing already installed: the 1250 gallon preplumbed two compartment tank. Norwesco's other 1250 gallon low profile tank: the 1250 gallon low profile septic tank. One size up: the 1500 gallon preplumbed one compartment tank. For Florida, the Florida only 1050 gallon two compartment tank.
Shipping and receiving
At 157 inches long the tank is an oversize shipment despite its 445 lb, and it travels on a flatbed or a long trailer from Norwesco's Griffin, Georgia plant. The listed price is before freight; the freight cost estimator gives the lane cost to your ZIP, or request a written quote for a job that needs paperwork. Have two people or a machine to take it off the truck. At the tailgate, check 43545 against the bill of lading, count the loose tee assemblies, and look along the ribs for transit damage before signing.
Questions before you order? Call 866-418-1777.
Freight and documents
Ships from: Griffin, GA. LTL freight is quoted to your ZIP with the freight cost estimator or by phone at 866-418-1777. The listed price is before freight.
Technical drawing (PDF) for Norwesco 43545.
See this tank
Product video. Watch the Norwesco 1250 Gallon Plastic Two Compartment Septic Tank with Loose Plumbing and Low Profile Design - IAPMO Certified video (71 seconds) with dimensions, fittings and shipping notes.
Ready to order?
Add it to your cart at the top of this page, get LTL freight to your ZIP, request a written quote, or call 866-418-1777. The listed price is before freight.
