Snyder Industries 2500 Gallon Black Heavy Duty Vertical Storage Tank

The Snyder Industries 2500 Gallon Black Heavy Duty Vertical Storage Tank is a polyethylene vertical storage tank built for high-density bulk water and liquid storage, standing 98 inches tall on a 96 x 96 inch footprint. The 1.9 specific gravity rating is the number that separates this tank from a standard water-only vertical: it gives you real headroom to store dense liquids, not just water at SG 1.0. If you are sizing a fire-water reservoir, a reuse storage train, or a heavy-duty bulk water buffer, the spec set here is the foundation for the decision.

Will this tank work for your job?

At 2500 gallons of capacity, a full charge of water weighs 20,850 pounds, and the tank's maximum rated contents weight runs to 39,615 pounds at the 1.9 SG rating. Those two numbers drive the rest of your planning. The 20,850 lb water-full figure tells you the static load your pad and grade must carry for ordinary water service; the 39,615 lb max-rated figure is the ceiling for denser contents and the load you design the foundation to. There is a real structural advantage in the proportions here: a 98 inch tall tank on a 96 inch base is a low height-to-diameter ratio, nearly one to one, which keeps the center of gravity down and lowers overturning risk compared with taller, narrower verticals of similar volume. The black polyethylene shell suits outdoor placement. Use the Tank Sizing Calculator and the Tank Sizing Guide to confirm this vertical storage tank matches your draw rate and refill cycle before you commit, and call 866-418-1777 to verify the exact bulkhead and outlet configuration for your order before you finalize your plumbing layout.

Foundation and placement

A black 2500 gallon vertical storage tank loaded to 20,850 pounds of water demands a level, full-contact base. Above-ground polyethylene tanks of this size need a properly sized, smooth concrete pad with uniform support across the entire bottom; our guide on concrete pad sizing for above-ground polyethylene tanks walks through the ACI 360R-10 framework so you do not under-build the slab. If this is a private fire-protection or rural water reservoir, the fire-water reservoir tank design guide covers NFPA 22 sizing discipline and freeze-protection engineering for cold-climate service. For grey-water, rainwater, or HVAC condensate aggregation, see the industrial water reuse tank topology guide.

The mistake to avoid

The common error on a heavy-duty vertical like this is treating the 1.9 SG rating as a license to store any dense liquid without checking the foundation math. At 1.9, this tank already sits at the heavy-duty top of the specific gravity range, so there is no need to step up to a higher-rated shell; the question is not whether the wall can take the load but whether your site can. The SG rating tells you the tank can handle the hydrostatic pressure of a denser liquid, but the 39,615 lb max-rated contents weight is what your pad, grade, and any anchoring must actually support. Spec your foundation to the real weight of your stored liquid, not to water alone, and do not assume the water-full number covers a denser contents load or the freeboard you lose to thermal expansion; the Snyder Captor freeboard sizing guide works through ASTM D1998 freeboard and the real usable volume at a given density.

This tank ships LTL freight exclusively from Chowchilla, CA, with freight quoted live to your ZIP, so request a quote early in planning, especially for sites away from the West Coast. Get an exact rate with the Freight Cost Estimator, or call 866-418-1777 for help sizing and placing a 2500 gallon black vertical storage tank for your site.